Purpose
Syntax
Related
Commands
Purpose
Command Modes
Syntax
tug-2 e1 framing ...............................................................68
tug-2 t1 framing................................................................70
unkowncast-limit ...............................................................71
vt-2 .................................................................................71
vtg e1 framing ..................................................................73
vtg t1 framing...................................................................75
au-3
When the cpos3 interface is configured to sdh mode, enter the
au-3 configuration mode with the au-3 command to configure an
au-3, and exit the au-3 configuration mode with the no command.
au-3 <au-3-number>
no au-3 <au-3-number>
<au-3-number>
It is only applied to ZXR10 GER.
This example describes how to enter the configuration mode of No.
1 au-3.
ZXR10(config-control)#framing sdh
aug mapping
au-4 tug-3
au-4 tug-3
When the cpos3 interface is configured to sdh mode and aug is
configured to au-4 mapping mode, enter the tug-3 configuration
mode with this command, and exit the tug-3 configuration mode
with the no command.
Channelization configuration
au-4 <au-4-number> tug-3 <tug-3-number>
no au-4 <au-4-number> tug-3 <tug-3-number>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
The value range of au-3 is 1~3
9