Channel-Group; Channelized - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Function
Command Mode
Format
Parameter
Description
Instruction
Example
Purpose
Command Modes
Syntax
Instructions
Example
14 Confidential and Proprietary Information of ZTE CORPORATION

channel-group

Use this command to configure the channel number and time slot
of E1 interface. Delete the channel with the no command.
Channelization configuration mode
channel-group <channel-number> timeslots <timeslots>
no channel-group <channel-number>
The parameter description of E1 interface:
<channel-number>
<timeslots>
The parameter description of T1 interface:
<channel-number>
<timeslots>
The command must be configured before the channelized E1 in-
terface takes effect. The configured time slot should be consistent
with the time slot configured at the peer end.
1. This example describes how to configure the channel number
of E1 interface as 1 and time slot number as 1~10.
ZXR10(config)#controller ce1_3/1
ZXR10(config-control)#channel-group 1 timeslots 1-10
ZXR10(config-control)#no channel-group 1
2. This example describes how to configure the channel number
of T1 interface as 1 and time slot number as 1~10.
ZXR10(config)#controller ct1_3/1
ZXR10(config-control)#channel-group 1 timeslots 1-10
ZXR10(config-control)#no channel-group 1

channelized

Use this command to set whether CE3 interface works in channel-
ization mode.
Channelization configuration

channelized

no channelized
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to set CE3 interface to work in non-
channelization mode.
ZXR10(config)#controller ce3_1/1
ZXR10(config-control)#no channelized
Channel number, in range of 1~31
Time slot number, in range of 1~31
Channel number, in range of 1~24
Time slot number, in range of 1~24