Syntax
Description
Defaults
Instruction
Example
Related
Commands
Purpose
Command Modes
Syntax
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
<max-user>
The maximum users that DHCP Snooping veneer supports is 2048.
Only when DHCP is in disable state, the configuration and deletion
operation that DHCP Snooping supports can be executed.
This command is only applied to switches.
This example shows how to set the DHCP Snooping maximum
users to 5120.
ZXR10(config)#ip dhcp snooping max-user 5120
show ip dhcp snooping configure
ip dhcp snooping ramble
Use this command to configure DHCP SNOOPING ramble function,
that permits user to switch between the different physical ports.
Disramble is the default setting.
Global configuration
ip dhcp snooping ramble
no ip dhcp snooping ramble
It is only applied to switches.
This example describes how to configure DHCP SNOOPING ramble
function.
ZXR10(config)#ip dhcp snooping ramble
ip dhcp snooping binding
ip dhcp snooping clear
ip dhcp snooping enable
ip dhcp snooping trust
Use this command to set the interface connected to the DHCP
SERVER to trust mode. Note that this command does not take
effect on the DHCP SERVER interface. By default, other interfaces
work in non trust mode.
Global configuration
Interface configuration
ip dhcp snooping trust [<interface-number>]
no ip dhcp snooping trust [<interface-number>]
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 DHCP and DHCP SNOOPING Configuration
The maximum users that DHCP Snooping
veneer supports, in the range of 1~32768.
103