Framingcpos3; Framingce1 - Zte ZXR10 8900 Series Command Reference Manual

Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
sonet
sdh
It is applied to ZXR10 GER.
This example describes how to set the framing mode to sdh.
ZXR10(config)#int pos48_1/1
ZXR10(config-if)#framing sdh

framingCPOS3

Use this command to configure the framing mode of CPOS3 inter-
face. Delete all interfaces which are created on the specified mode
with the no command.
Channelization configuration
framing {sonet | sdh}
no framing {sonet | sdh}
sonet
sdh
It is applied to ZXR10 GER.
This example describes how to configure the framing mode of
CPOS3 to sdh.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
framing CE1
Use this command to configure the framing mode of E1 interface
board.
Channelization configuration
framing {unframed | frame}
unframed
frame
Framing mode
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Sets the framing mode of pos to sonnet mode.
Sets the framing mode of pos to sdh mode.
Sets the framing mode of CPOS3 interface to
sonnet mode.
Sets the framing mode of CPOS3 interface to
sdh mode.
Unframed mode
Framing mode
27