Ip Dhcp Enable; Ip Dhcp Mode - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
82 Confidential and Proprietary Information of ZTE CORPORATION
It is only applied to 59 series switches.
This example shows how to set the parameter requesting list of
dhcp client example.
ZXR10(config-if)#no ip dhcp client request router
ZXR10(config-if)#

ip dhcp enable

Use this command to start the built-in DHCP process. Use the
command no to stop DHCP process.
Global configuration

ip dhcp enable

no ip dhcp enable
The built-in DHCP process is disabled.
� After starting the built-in DHCP process, system processes IP
address request of DHCP protocol on the interface which is
configured user interface attribution.
� DHCP Server and DHCP Relay functions are configured inside
system, start these two functions through this command.
This example describes how to enable built-in DHCP function.
ZXR10(config)#ip dhcp enable

ip dhcp mode

Use this command to start DHCP working mode on interface.
Interface configuration
ip dhcp mode [server | relay | proxy]
relay
server
proxy
By default all are disable.
After start the built-in DHCP Relay process, system will resolve
DHCP Client's IP address request on configured user interfaces,
dynamically assign IP address for DHCP Client through external
DHCP Server configured on interfaces.
After starting the inside DHCP Server process, system will resolve
DHCP Client's IP address request on configured user interfaces,
Enables the DHCP Relay function on an
interface.
Enables the DHCP Server function on an
interface.
Enables the DHCP Proxy function on an
interface.