Sts-1; Sts-3 - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
64 Confidential and Proprietary Information of ZTE CORPORATION
ZXR10(config)#interface serial_1/1
ZXR10(config-if)#stopbits 1

sts-1

After the cpos3 interface is set to the SONET mode, you can use
the sts-1 command to enter the configuration mode of STS-1, and
use the no command to exit the configuration mode.
Channelization configuration
sts-1 <number>
no sts-1 <number>
<number>
It is applied only to ZXR10 GER.
This example describes how to enter the configuration mode of
STS-1 that is numbered 1.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sonet
ZXR10(config-control)#sts-1 1

sts-3

Use this command to create cpos48 sub interfaces when the
cpos48 interface is configured to sonet mode.
P48sdh controller configuration
sts-3 <number-list>
no sts-3 <number-list>
<number-list>
It is applied only to ZXR10 T128.
� This example shows how to create a cp48 sub interface that
takes up No.1 channel.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sonet
ZXR10(config-control)#sts-3 1
� This example shows how to create a cp48 sub interface that
takes up 1-4 channels.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sonet
ZXR10(config-control)#sts-3 1-4
Ranging 1–3
Ranging from 1~16, such as 1-4, 5-8, 9-12,
13-16 and 1-16.