ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
20
Confidential and Proprietary Information of ZTE CORPORATION
duplex {auto | half | full}
e1 channel-group timeslots
Use this command to create an E1 channelized sub interface when
CE3 interface works in channelization mode. Delete this interface
with the no command.
Channelization configuration
e1 <line> channel-group <channel-number> timeslots <time
slots>
no e1 <line> channel-group <channel-number>
<line>
<channel-number>
<timeslots>
It is only applied to ZXR10 GER, ZXR10 T64E/T128.
This example describes how to configure an interface, the E1 num-
ber is 1, the channel number is 1, and delete this interface at last.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)#e1 1 channel-group 1 timeslots 1-31
ZXR10(config-control)#no channel-group 1
e1 clock source
Use this command to configure the clock source of interface E1.
Restore the default value with the no command.
Channelization configuration
e1 <line> clock source {internal | line}
no e1 <line> clock source
<line>
line
internal
Clock mode is internal by default.
It is only applied to ZXR10 GER, ZXR10 T64E/T128.
This example describes how to configure the clock source of the
No.1 E1 channel as line clock.
E1 number, the range 1~16
Channel number, can only be 1
Timeslot number, the timeslots 1~31 have to
be assigned to an interface at one time.
E1 number, the range 1~16
Line clock
Internal clock