Port-Hold Time; Qinq; Qinq Range - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Purpose
Command Modes
Syntax
44 Confidential and Proprietary Information of ZTE CORPORATION

port-hold time

use this command to set the port hold time of an Ethernet inter-
face. Restore the default value 0 with the no command.
Interface configuration
port-hold time <time>
no port-hold time
<time>
It is applied to ZXR10 T128/T600 and ZXR10 SW.
This example shows how to configure the hold time of fei_1/1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)# port-hold time 10

qinq

Use this command to configure the tags of internal VLAN and ex-
ternal VLAN.
VLAN sub interface configuration
qinq internal-vlan <1-4094> external-vlan <1-4094>
internal-vlan<1-40
94>
external-vlan
<1-4094>
It is applied to Ethernet sub interface.
The internal tag and external tag can not be overlapping on the
sub interface of the same physical interface at the same time.
This command can not be configured together with qinq range
command, encapsulation dot1Q range command and encapsu
lation dot1Q command.

qinq range

Use this command to configure the tags of internal VLAN and ex-
ternal VLAN
VLAN sub interface configuration
For high end routers:
Hold time, in its unit of second, ranging from
0 to 1200
Tag of internal VLAN
Tag of external VLAN