E1 National Bits; E1 Unframed - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
22 Confidential and Proprietary Information of ZTE CORPORATION
Do not support the loopback function by default.
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to configure the loopback mode of E1
channel 1 to local loopback.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)#e1 1 loopback local

e1 national bits

Use this command to set the national bits parameter of E1 channel.
Restore default with the no command.
Channelization configuration
e1 <line> national bits <pattern>
no e1 <line> national bits
<line>
<pattern>
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to configure national bits of E1 chan-
nel 1 as 1.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)#e1 1 national bits 1

e1 unframed

Use this command to set E1 channel to work in unframed mode,
and create an E1 unframed sub interface. Set E1 to work in fram-
ing mode with the no command.
Channelization configuration
e1 <line> unframed
no e1 <line> unframed
<line>
E1 works in the framing mode.
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to create an unframed sub interface
of E1 1.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)#e1 1 unframed
E1 number, in the range of 1~16
0~31, 0 by default
E1 number, in the range of 1~16