Multicast-Limit - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
40 Confidential and Proprietary Information of ZTE CORPORATION
For ethernet interface, POS interface, CPOS48 interface, ce1 inter-
face and SmartGroup interface on T128 rack: mtu <128-1600>
For CP3 interface and mppp interface on T128 rack: mtu <128-1
600>
For ethernet interface, POS interface, CPOS48 interface, ce1 inter-
face and SmartGroup interface on T600 rack: mtu <128-7680>
For CP3 interface and mppp interface on T600 rack: mtu <128-5
120>
<128-1600>
<128-7680>
<128-5120>
� For POS/CPOS (CP3 and CP48) interface, the mtu is 4470.
� For Ethernet interface, the mtu is 1600.
This example shows how to set the MTU of a seral interface fei_3/1
to 168.
ZXR10(config-if)#mtu 168
ZXR10(config-if)#show run interface fei_3/1
Building configuration...
!
interface fei_3/1
physical-layer mode npct
mtu 168
!
end

multicast-limit

Use this command to set the limit rate (in percent) to multicast
packets on the Ethernet port. Restore the default with the no
command.
Interface configuration
multicast-limit <percent-value>
no multicast-limit
<percent-value>
no multicast-limit and multicast-limit 100 have the same
function.
This example describes how to set the rate limit (in percent) to
multicast packets on port fei_1/1 to 10.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#multicast-limit 10
The value of MTU
The value of MTU
The value of MTU
Limit rate to multicast packets, ranging
1–100, 100 by default.