Unkowncast-Limit; Vt-2 - Zte ZXR10 8900 Series Command Reference Manual

Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
esf
sf
Framing in the sf mode.
It is applied only to ZXR10 GER.
This example describes how to set the T1 channel to work in the
frame mode of esf.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#aug mapping au-3
ZXR10(config-control)#tug-2 1 t1 1 framing frame
ZXR10(config-control)#tug-2 1 t1 1 framing esf

unkowncast-limit

Use this command to configure the limit (percent) for unknown
packets on the Ethernet port. Restore default with the no com-
mand.
Port configuration
unknowcast-limit <percent-value>
no unknowcast-limit
<percent-value>
This example describes how to set the limit for unknown packets
on the port fei_1/1 to 10%.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#unkowncast-limit 10
set interface unknowcast-limit

vt-2

Use this command to enter the vt-2 configuration mode when the
cpos3 interface is configured with the sonet mode. Exit the vt-2
configuration mode with the no command.
Channelization configuration
vt-2 <number>
no vt-2 <number>
<number>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Sets the frame format to esf if the T1 channel
works in the frame format.
Sets the frame format to sf if the E1 channel
works in the frame format.
Limit percent for unknown packets, 1 ~ 100,
100 by default.
The value is 1.
71