Flag C2; Flag J0 - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
24 Confidential and Proprietary Information of ZTE CORPORATION
� The no command is used to set the <vlan-id> encapsulated
for the subinterface to 0. In this case, the packet cannot be
received and sent.
� After configuring VPN, ACL, NAT and QOS attributes on the
subinterface and before removing the above attributes, it is
unable to remove encapsulation (with the no command) or
change encapsulation.
� This command can not be configured with any one of qinq,
qinq range and encapsulation dot1Q.

flag c2

Use this command to set POS /ATM port signal access sign.
Interface
flag c2 <value>
no flag c2
<value>
System default configuration (0x01).
Default POS/ATM SDH as 0x01, SONET as 0xcc, this command
used for POS interface and ATM interface.
This example shows how to set POS port signal access sign.
ZXR10(config)#int pos48_1/1
ZXR10(config-if)#flag ?
c2 path overhead byte
j0 section trace byte
s1s0 Specify bit S1 and S0 of H1
ZXR10(config-if)#flag c2 ?
<0-255> Byte value
ZXR10(config-if)#flag c2 2

flag j0

Use this command to set POS port and ATM port section trace sign
field J0. Restore POS port section trace sign field J0 with the no
command.
Interface configuration
flag j0 <value>
no flag j0
<value>
System default configuration (0x01)
The range is 0~255
in the range of 0~255