Loopback(Ce3); Loopback - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
36 Confidential and Proprietary Information of ZTE CORPORATION

loopback(CE3)

Use this command to set the loopback mode of the CE3 channel.
Restore the default with the no command.
Channelization configuration
loopback {local|remote{payload|network}}
no loopback
local
remote payload
local network
No loopback is supported
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to set the loopback mode of the CE3
channel to local.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)#loopback local

loopback

Use this command to set the loopback mode of the pos and cpos
channel. Restore the default with the no command.
Channelization configuration and interface configuration
loopback {internal|line}
no loopback
internal
line
No loopback is supported.
It is applied to ZXR10 T64E/T128/T600/T1200.
This example describes how to set the loopback mode of CPOS48
channel to internal.
ZXR10(config)#controller cpos48_1/1
ZXR10(config-control)#loopback internal
Sets the loopback mode to local
Sets the loopback mode to remote payload
Sets the loopback mode to remote network
Sets the loopback mode to internal
Sets the loopback mode to line