Negotiation Auto; Npc-Type; Parity - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Purpose
42 Confidential and Proprietary Information of ZTE CORPORATION

negotiation auto

Use this command to activate auto-negotiation of the Ethernet in-
terface. Disable auto-negotiation of the Ethernet interface with
the no command.
Interface configuration
negotiation auto [speed {10|100}]
no negotiation auto
10
100
Auto-negotiation is enabled.
This example describes how to enable auto-negotiation on inter-
face gei_2/1.
ZXR10(config)#interface gei_2/1
ZXR10(config-if)# negotiation auto

npc-type

Use this command to set the type of the current NPC board.
Interface configuration
npc-type {npci|npct}
npci
npct
� The platform version 4.6.02 and upgrade versions support this
command.
� The command is applied only to ZXR10 T128. Actually, config-
uration with this command is unnecessary, for the T128 project
ensures the correctness of configuration restoration (read from
the database) after a different NPC interface board is replaced
in the slot.

parity

Use this command to set the parity check type of the asynchronous
serial port.
Sets the interface negotiation auto to 10M
Sets the interface negotiation auto to 100M
Sets the NPC board of the current interface
to npci.
Sets the NPC board of the current interface
to npct.