Speed Type - InfoPrint 6500 Series User Manual

Chapter 3
Network Configuration

Speed Type

Change the selected bit-rates. Choosing "auto" will select auto settings even if
some or all of the checkboxes are selected. To manually choose bit-rates,
change speed option to "user" and check the appropriate checkboxes. If
"user" is selected, and no checkboxes are checked, then the automatic
setting is used.
Speed
Checkmark the appropriate checkboxes to manually choose the bit-rates.
NOTE: The Speed Type must be set to "user". If "user" is selected, and no
checkboxes are checked, then the automatic setting is used.
Channel
NOTE: For 802.11b only radio, not 802.11g/b.
This is the frequency used for wireless communication. The 2.4GHz band
spectrum is divided into different channels (1-15). It is set to "Default" so that
the ethernet can detect the correct channel to communicate with the Access
Point in infrastructure mode. If the operation mode is "Ad Hoc" and the
channel is known, the user can set the corresponding channel in this menu.
Antenna
Choose the antenna type. Diverse, Primary, and Aux are the available
settings.
Preamble
NOTE: For 802.11b only radio, not 802.11g/b.
This is the preamble used in the wireless packets. It is recommended to set to
"Default" so that the ethernet can detect the correct preamble. The preamble
is approximately 8 bytes of the packet header generated by the AP is and
attached to the packet prior to transmission. The preamble length is
transmission data rate dependent. The "short" preamble is 50% shorter than
the "long" preamble. Transmit power is 0–100%. It must match the Access
Point's preamble configuration.
Power Mgmt Mode
Change the power management mode and adjust the power-save sleep time
(milliseconds). Selecting "Off" will turn the Power Management Mode off and
set the power-save sleep time to zero.
Transmit Power
Adjust RF transmit power in percent of full power.
44