Verifying A Tcp/Ip-Attached Printer On Z/Os - InfoPrint 6500 Series User Manual

Chapter 8
Configuring PSF for z/OS to Print IPDS Files
//* DEFAULT PAGEDEF AND CHARS ARE SPECIFIED BY JES3
//* PAGEDEF=A868
//* CHARS=60D8
//PRT3 ENDCNTL
NOTE: If you are using the Printer Inventory the parameters in bold must be defined.
NOTE: To specify a TCP/IP address space name other than the default,
The IP address is the only required parameter. Other parameters may be set
to facilitate printer sharing as described in "Sharing InfoPrint 6500-V Printers
on z/OS" on page 143. For a description of the PRINTDEV statement, which
is not given here, see the PSF System Programming Guide.
IPADDR
Specifies the IP address for the printer or attachment, in dotted-decimal
notation. Do not specify a hostname in place of the dotted-decimal address.

Verifying a TCP/IP-Attached Printer on z/OS

To operate a TCP/IP-attached printer, use JES operator commands.
Starting a TCP/IP-attached Printer
To start a TCP/IP-attached printer, do the following:
1. Start TCP/IP.
2. Power on the printer.
3. Start the printer FSA.
•
$Sprinter_name
•
*VARY printer_name,ON
142
/* COPY OF A08682
/* JES3 DEFAULT FONT
TCPIP, code the following exec statement in the writer procedure:
//STEP01EXEC PGM=ASPPIEP,REGION=4096K,
PARM=(,,,,tcpip_name)
where tcpip_name is the name of the TCP/IP address space. If this
parameter is not coded, PSF uses the default name, TCPIP.
On JES2, the command is:
On JES3, the command is:
*/
*/
*/