InfoPrint 6500 Series User Manual page 195

set model from stored
Set all current model settings to the values stored in flash memory.
set prn [-]autofd
Example: set prn -autofd
Assert or do not assert the AUTOFD line for carriage return insertion. This
only affects printers that support this function, such as impact printers.
set prn flush
Flush the data in the parallel port input and output buffers.
set prn unlock
Release the access lock on the parallel port.
set prn timeout <INT>|none
Example: set prn timeout none
Terminate the print job sent to the parallel port if it is not printed after the
timeout period in minutes (<int>) expires. The <int> value ranges from 0
though 255, with 0 indicating no timing out to take place. This is the
default setting and should be fine for most print setups.
set prn [-]opost
Example: set prn -opost
Allow or disallow output processing on the parallel port such as carriage
return insertion (e.g., onlcr).
set prn [-]onlcr
Example: set prn -onlcr
Enable or disable carriage return insertion on the parallel port. This may
be needed for Unix text jobs coming through with solitary linefeeds. This
feature is almost always set at the model level rather than the I/O port
level.
set prn xtab <INT>|none
Example: set prn xtab none
Set the tabstop width as indicated by <int>. The range is 1 through 16
spaces.
set prn from default
Set all parallel port settings back to factory defaults.
set prn from stored
Set all current parallel port settings to the values stored in flash memory.
Set Commands
195