Web Browser/Http Problem - InfoPrint 6500 Series User Manual

9. At the system prompt, enter:
store tcpip from default
config http on
save
reset
NOTE: This will reset all TCP/IP settings to factory default and reset the
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway parameters to the
desired values.
WIRELESS,
To reset all integrated ethernet TCP/IP values to the factory defaults when
access is impossible, contact your InfoPrint Solutions service representative
for assistance.
ETHERNET

Web Browser/HTTP Problem

In some cases, you may not be able to browse the printer Web page simply
because the ethernet HTTP may be turned off.
If you cannot ping the ethernet IP address, make sure the IP Address, subnet
mask, and default gateway are set correctly by checking the Ethernet
Parameters menu from the operator panel. See the InfoPrint 6500 Line Matrix
Printers: User's Manual for configuration menu information.
If you can ping the ethernet interface IP address but cannot access the Web
pages, perform the following procedure to verify the ethernet HTTP is turned
on.
1. Telnet into the ethernet and log in as root. There is no password by
default.
2. At the system prompt, enter the following commands:
config http on
save
reset
3. After approximately 30 seconds, point your browser to the ethernet IP
address. The printer Web pages should now be accessible.
ethernet.
Web Browser/HTTP Problem
85