InfoPrint 6500 Series User Manual page 193

ioport Printer error messages determined through the parallel
port pins.
set logpath <LOGPATH> port <TCP-port>|email|syslog
Example: set logpath l3 port 2000
Determine where the log information should be sent for a print job or
attached printer. The choices are:
TCP-port TCP port number ranging from 1024 to 65000.
email Particular user's email address. This address is set
using the set sysinfo email
emailname@IPaddress or
emailname@domain.com command.
syslog A central TCP/IP host running the SYSLOG daemon.
This host is set using the set sysinfo syslog
IPaddress command.
set logpath from default
Set all logpath settings back to factory defaults.
set logpath from stored
Set all current logpath settings to the values stored in flash memory.
set lpd
Example: set lpd [-]bytecount
Set the job control on the file size of a Line Printer Daemon (LPD). If
bytecount is enabled, the printer does not allow the LPD client to send a
job with an unconventional file size. Usually the unrecognized numeric
operand in the LPD Receive Data File command attributes to this
behavior. The print job stream is canceled and its TCP connection is
closed.
Default: Disabled.
set model <MODEL> name <NEW_NAME>
Example: set model m1 name landscape
Change the current name of the model (<model>) to a new name as
indicated by <new_name>. These names are case sensitive.
set model <MODEL> type raw
Example: set model m2 type raw
Set the model type to raw so that it does not process the data passing
through it in any way.
set model <MODEL> banner [text][after]
Example: set model m2 banner text
Determine whether a banner page should be added for print jobs passing
through the <model> mapped destination/queue.
By default, banner pages are added to the front of the job.
If after is set, the banner page will come at the end.
Set Commands
193