InfoPrint 6500 Series User Manual page 196

Chapter 13
Complete Command List
set snmp
To add a user named snmp with root privileges, follow the steps below:
1.Login to the NIC as a root user.
2.Add a user named snmp:
3.Set the user type to root:
4.Set the password for the snmp user:
5.Save the changes:
The user snmp is now created and snmppassword is the only community
set snmp manager <INDEX> <IPADDRESS> <TRAP-COMMUNITY>
The NIC continuously generates traps. To set the NIC to send traps to a
particular SNMP manager, use this command to add an SNMP manager
to the trap table.
<index> is the index number of the trap table. <ipaddress is the IP address
of the SNMP manager receiving traps. <trap-community> is the
community string sent along with the trap information.
set snmp trapport <INDEX> <UDP_PORT>
Set the UDP port number in the SNMP trap manager table. This value
should correspond to the port number monitored by the SNMP manager
application running on the host at the IP address specified in the 'set
snmp manager' command.
<index> is the index number of the SNMP trap manager table.
<udp_port> is the desired UDP port number. Acceptable values are 162,
and 49152 through 65535.
set snmp trap <INDEX> [-]active
Enable or disable an SNMP trap manager table entry.
The index is the index number of the SNMP trap manager table. "active"
enables the table entry, "-active" disables the entry.
set snmp emailaddr <INDEX> <EMAILADDRESS>
The NIC can also send SNMP alert messages to a desired e-mail
address. To specify an e-mail address to send alert messages to, use
this command to add the e-mail address to the SNMP alert table.
<index> is the index number of the SNMP trap manager table. The
emailaddress is the desired e-mail address of the form
user@domain.com.
196
set user add snmp
set user type snmp root
set user passwd snmp snmppassword
save
string which will allow write access.