InfoPrint 6500 Series User Manual page 121

arp -s <ipaddress> <MACaddress>
ping <ipaddress>
7. Try to ping this IP address to see if the ethernet can be seen on your
network. If the interface does not respond, verify you are on the same
network segment as the printer and that the ARP entry was created.
8. Telnet into the ethernet using the same IP address as above. Log in as
root with no password.
9. At system prompt, enter:
store tcpip from default
config http on
reset
NOTE: This will reset all TCP/IP settings to factory default and reset the
ethernet.
10. Wait five minutes for the ethernet to reset.
11. Power the printer off and then back on.
12. Wait for the "ETHERNET IS READY" message to display.
13. Set the IP address, subnet mask, and default gateway parameters to the
desired values. (See "Configuration Tools" on page 20.)
TCP/IP Access Problem
121