Front Panel Message - Dynamically Set Params Read Only - InfoPrint 6500 Series User Manual

Chapter 5
Unix Troubleshooting Tips
7. Try to ping this IP address to see if the ethernet can be seen on your
network. If the interface does not respond, verify you are on the same
network segment as the printer and that the ARP entry was created.
8. Telnet into the ethernet using the same IP address as above. Log in as
root with no password.
9. At the system prompt, enter:
store tcpip from default
config http on
reset
NOTE: This will reset all TCP/IP settings to factory default and reset the
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway parameters to the
desired values.
12. If the Web browser access does not work, telnet into the ethernet as
root. Enter the following command:
config http on
ETHERNET,
To reset all integrated ethernet TCP/IP values to the factory defaults when
WIRELESS access is impossible, contact your InfoPrint Solutions service representative
for assistance.
Front Panel Message - Dynamically Set Params Read
Only
This is not an error. It is an informational message warning that the IP
address has been dynamically set by dhcp, rarp, or bootp.
To assign a static IP address, turn off the rarp, bootp, and dhcp on the
Ethernet. Use the following procedure:
1. Telnet to the Ethernet. Login = root, password = (Enter key)
Telnet commands are:
store tcpip 1 opts -rarp -bootp -dhcp
reset
Wait two minutes for the Ethernet to reset.
2. Program the IP address, Subnet Mask, and Gateway (if required) from
the front panel.
108
ethernet.