InfoPrint 6500 Series User Manual page 53

Filter
Specify whether the ethernet interface is to add carriage returns to print jobs
passing through that contain solitary linefeeds. This is common with Unix text
jobs resulting in stair-stepped output.
Header String
Define an escape sequence to be sent to the printer before each print job. For
example, you may want to send a sequence to print the job in landscape
mode or to a certain tray on the printer. You can specify up to four separate
sequences per header string. The ethernet enterface will execute them in
order from top to bottom. If specifying fewer than four sequences, be sure to
start at the top leaving undefined fields at the bottom.
NOTE: You can specify up to four separate sequences per header string.
The Printer Management Utility will execute them in order from top to
bottom. If specifying fewer than four sequences, be sure to start at
the top leaving undefined fields at the bottom.
The most common sequences are listed on the form:
•
Print landscape - tell the printer to print in landscape mode.
•
Print portrait - tell the printer to print in portrait mode.
Trailer String
Define an escape sequence to be sent to the printer after each print job. For
example, you may want to send a sequence to add a formfeed so you don't
have to manually press the formfeed button on the printer. You may also want
to tell the printer to reset itself in case you have set a header string which tells
the printer to do something special with the job. You can specify up to three
separate sequences per trailer string. The ethernet interface executes them in
order from top to bottom. If specifying fewer than three sequences, be sure to
start at the top leaving undefined fields at the bottom.
The most common sequences are listed on the form:
•
PCL Reset - tells the printer to reset itself once the data completes
•
End of Transmission (EOT) - tells the printer to force the end of the job
•
Formfeed - tells the printer to do a formfeed at the end of the data.
Print Model Configuration
Current Model Settings
53