InfoPrint 6500 Series User Manual page 102

Chapter 5
Ethernet Configuration for AIX 4
Name of queue
Host Name of Remote Server
Name of Queue on Remote
Server
Type of Print Spooler
Troubleshooting
This installation procedure assumes that the ethernet is configured with the
correct IP address, subnet mask, and gateway (if required). In addition you
can also ping and telnet to the ethernet.
Print an ethernet test page to verify the ethernet settings. See "Configuration
Using The Control Panel" on page 21.
The default ethernet queue name is d1prn (in lower case), however the name
can be changed. To verify the queue name, print an E-Net Test Page or telnet
to the adapter and do a "list dest" command.
Local Filtering
1. Enter smitty mkvirprt.
2. Add Remote Print Queue.
3. Set the type of Remote Printing to Local Filtering...
4. Set the Printer Manufacturer to Other.
5. Set the Printer Type to the appropriate driver (if there is no driver
available, select Generic).
6. Enter the following Remote Print Queue with Local Filtering settings:
Name of queue
Host Name of Remote Server
Name of Queue on Remote Server
Type of Print Spooler
Leave Pass-Through Flag
102
any_name, user selectable
name in /etc/hosts file or the
ethernet IP address
d1prn
BSD (Press the list button and
choose BSD)
any_name, user selectable
(if there is a selection, choose ASCII)
name in /etc/hosts file OR the ethernet IP address
d1prn
BSD (Press the list button and choose BSD)
Yes