InfoPrint 6500 Series User Manual page 192

Chapter 13
Complete Command List
set dest <DEST> service [[-]socket][[-]lpd]
[[-]lpsched] [[-]rprinter] [[-]pserver] [[-]netbios] [[-]ftpd]
[[-]tn]
Example: set dest d1prn service -netbios
Set the destination (<dest>) to handle only certain print services. To add a
service, specify the service name. To disable a service, use "
name. The available services are described in the following table.
Services
socket
lpd
lpsched
netbios
ftpd
tn
set dest from default
Set all destination settings back to factory defaults.
set dest from stored
Set all current destination settings to the values stored in flash memory.
set ifc
Example: set ifc <IFNUM> up|down
Set state of the specified network physical interface up or down. <ifnum>
is the interface number for the NIC device.
set logpath <LOGPATH> name <NEW_NAME>
Example: set logpath l1 name pagecount
Change the current name of the logpath (<logpath>) to a new name as
indicated by <new_name>. These names are case sensitive.
set logpath <LOGPATH> type [[-]job] [[-]user]
[[-]cksum] [[-]printer] [[-]ioport]
Example: set logpath l2 type job user printer pgcnt
Establish the type of printer and print job logging to be done within this
<logpath>. The options are:
job
user
cksum
printer
192
Direct socket printing via TCP/IP.
LPR printing with TCP/IP, including LPR clients on any
platform.
LP or System V printing with TCP/IP.
Windows 95 and Windows for Workgroups printing.
Printing using the File Transfer Protocol (FTP) via TCP/IP.
Printing using the TN5250/3270 session.
Job ID, username, etc.
User ID along with three messages per job about start
and finish.
16-bit checksum value to confirm integrity of data
printed.
For special printer feedback.
" before the
-