Sfcc Separator; Sfcc Terminator; Euro Symbol; Speed Cmds - InfoPrint 6700 Series Programmer's Reference Manual

Chapter 1
TGL SETUP Menu

SFCC Separator

This menu is only present when "User Defined" is selected in the SFCC
menu. SFCC-Separator can be set to any value between 0x0 and 0xFF. The
factory default is 0x7C.

SFCC Terminator

This menu is only present when "User Defined" is selected in the SFCC
menu. SFCC-Terminator can be set to any value between 0x0 and 0xFF.
The factory default is 0x7D.

EURO Symbol

This menu allows you to configure the position of the EURO symbol in the
code pages. EURO Symbol can be set to any value between 0x20 and 0xFF.
The factory default is 0xB0.

Speed CMDs

This option allows you to choose whether the engine commands that affect
the print/feed speed should be processed or ignored. To adjust the print/feed
speed through the front panel, use this menu to prevent the host commands
from overriding these settings. When you select "Ignore," TGL ignores the
following commands or command parameters:
•
The print speed parameter in the XS command. The parameter will have
no effect; the "Print Speed" value as configured in the "MEDIA
CONTROL" menu will be used.
•
The feed speed parameter in the T command. The parameter will have no
effect; the "Slew Speed" value as configured in the "MEDIA CONTROL"
menu will be used.
The factory default is Process.

AY Intensity CMD

This option allows you to choose whether the engine command to set the print
intensity (AY) should be processed or ignored. If you want to adjust the print
intensity through the front panel, use this menu to prevent the host commands
from overriding these settings. When you select "Ignore," the AY command
will be ignored and "Print Intensity" as configured in the "MEDIA CONTROL"
menu will be used.
The factory default is Process.

U1/U2 Move CMDs

This option allows you to choose whether the engine command to move
paper forward (U1) or backward (U2) will be processed or ignored. When you
select "Ignore," the paper will not be moved when either command is
received.
The factory default is Process.
10