InfoPrint 6500 Series User Manual page 128

Chapter 7
Configuring On iSeries As An IPDS Printer
3. The following parameters are recommended: PSF configuration
(PSFCFG)
The name used for this PSF configuration object. The name must match the
user-defined object name (USRDFNOBJ) in the printer DEVD.
PSF configuration (PSFCFG)
The name used for this PSF configuration object. The name must match the
user-defined object name (USRDFNOBJ) in the printer DEVD.
IPDS pass through (IPDSPASTHR)
To print SCS files, specify *YES, PSF transforms SCS into IPDS before
printing. For V5R4 and higher, this value should be *NO."
Release timer (RLSTMR)
Specifies the amount of time to wait before a session or dialog is released
without terminating the writer. The ACTRLSTMR parameter specifies when
this timer is to be activated. Set the parameter to a value at least equal to the
TIMEOUT value on the printer. InfoPrint recommends *SEC15.
Page size control (PAGSIZCTL)
Specifies if the page size (forms) is set by PSF. Usually set to *YES.
Configuring PSF with CRTDEVPRT On V4R2 and above
This section describes how to create a printer device description.
1. At the iSeries command line, enter a command in the form:
CRTDEVPRT DEVD(P6500-V) DEVCLS(*LAN) TYPE(*IPDS)
MODEL(0)
LANATTACH(*IP) AFP(*YES) PORT(5001) FONT(11)
FORMFEED(*CONT) RMTLOCNAME('128.9.12.134')
USRDFNOBJ(AFP/NETPRT6500-V *PSFCFG)
TEXT('InfoPrint 6500-V NETWORK PRINTER')
Only use the USRDFNOBJ parameter if it was defined in the previous
procedure.
A completed screen looks like the example shown in Figure 41.
128