Speed Setting For 10/100Base-T - InfoPrint 6500 Series User Manual

Speed Setting for 10/100Base-T

When the router is set to auto-negotiation enable, the following is the correct
behavior of the ethernet interface with each setting:
1. 10mbps Half Duplex
Use parallel detection because the ethernet interface is using force mode
and thus has auto-negotiation disabled.
PORs to Half Duplex. Resets to Half Duplex. Reconnection at switch
maintains Half Duplex.
2. 10mbps Full Duplex
Use parallel detection because the ethernet interface is using force mode
and thus has auto-negotiation disabled.
PORs to Half Duplex. Resets to Half Duplex. Reconnection at switch
maintains Half Duplex.
3. 100mbps Half Duplex
Use parallel detection because the ethernet interface is using force mode
and thus has auto-negotiation disabled.
PORs to Half Duplex. Resets to Half Duplex. Reconnection at switch
results in Half Duplex.
4. 100mbps Full Duplex
Use parallel detection because the ethernet interface is using force mode
and thus has auto-negotiation disabled.
PORs to Half Duplex. Resets to Half Duplex. Reconnection at switch
results in Half Duplex.
5. Ethernet in Auto mode in 100mbps Full Duplex environment
Use auto negotiation to the highest common local and remote capability,
i.e. 100 Full Duplex in this case.
PORs to 100/Full Duplex. Resets to 100/Full Duplex. Reconnection at
switch remains 100/Full Duplex.
6. Ethernet in Auto mode in 10mbps Half Duplex environment
(determined using 10hd hub)
Use auto-negotiation to the highest common local and remote capability,
i.e. 100 Half Duplex in this case.
PORs to 10 Half Duplex. Resets to 10 Half Duplex. Reconnection at
switch maintains 10 Half Duplex.
NOTE: With parallel detection, only speed can be determined. The duplex
mode sets to half duplex.
Speed Setting for 10/100Base-T
17