D-Link xStack Reference Manual page 1064

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Password Title
Logout Window Title
Notification
Copyright @ 2011 D-Link All Rights Reserved
DGS-3120-24TC:admin#
116-19 clear wac auth_state
Description
This command is used to clear the authentication state of a port. If the port is port-based mode, the
port will return to un-authenticated state. The entire timer associated with the port will be reset.
If the port is host based mode, users on this port will be cleared. The user needs to be re-
authenticated to access the network.
Format
clear wac auth_state [ports [<portlist> | all] {authenticated | authenticating | blocked} |
macaddr <macaddr>]
Parameters
ports - Specify the list of ports whose WAC state will be cleared.
<portlist> - Enter a list of ports used for the configuration here.
all - Specify that all the ports will be used for this configuration.
authenticated - (Optional) Specified to clear all authenticated users for a port.
authenticating - (Optional) Specified to clear all authenticating users for a port.
blocked - (Optional) Specified to clear all blocked users for a port.
macaddr - Specify the MAC address of the users to be cleared.
<macaddr> - Enter the MAC address of the users to be cleared here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete WAC hosts on ports 1 to 5:
DGS-3120-24TC:admin#clear wac auth_state ports 1:1-1:5
Command: clear wac auth_state ports 1:1-1:5
Success.
DGS-3120-24TC:admin#
: Password
: Logout From The Network
:
1059