5.8
Provisioning MLPP Parameters
This section describes how to configure the MLPP (Multi-Level Precedence and
Preemption) parameters using the EMS.
To configure the MLPP parameters:
1.
In the MG Tree, select the device.
2.
Select the SIP > Advanced
3.
Select the
4.
Configure the MLPP parameters as required.
Notes:
SIP User's Manual
tab; the 'SIP Advanced Configuration' frame appears.
MLPP
tab; the following screen appears:
Figure 5-10: MLPP Screen
•
•
If the following RTP DSCP parameters are set to "-1" (i.e., Not
Configured, Default), the DiffServ value is set with the
PremiumServiceClassMediaDiffserv global gateway parameter, or by
using IP Profiles: MLPPRoutineRTPDSCP, MLPPPriorityRTPDSCP,
MLPPImmediateRTPDSCP, MLPPFlashRTPDSCP,
MLPPFlashOverRTPDSCP, MLPPFlashOverOverRTPDSCP,
MLPPNormalizedServiceDomain.
216
Mediant 2000
Document #: LTRT-68809