Figure 3-68: Coder Group Settings - AudioCodes Mediant 2000 User Manual


To configure coder groups:
1. Open the 'Coder Group Settings' page (Configuration tab > Protocol Configuration
menu > Coders And Profile Definition submenu > Coder Group Settings
item).
2. From the 'Coder Group ID' drop-down list, select a coder group ID.
3. From the 'Coder Name' drop-down list, select the first coder for the coder group.
4. From the 'Packetization Time' drop-down list, select the packetization time (in msec)
for the coder. The packetization time determines how many coder payloads are
combined into a single RTP packet.
5. From the 'Rate' drop-down list, select the bit rate (in kbps) for the coder you selected.
6. In the 'Payload Type' field, if the payload type for the coder you selected is dynamic,
enter a value from 0 to 120 (payload types of 'well-known' coders cannot be modified).
The payload type identifies the format of the RTP payload.
7. From the 'Silence Suppression' drop-down list, enable or disable the silence
suppression option for the coder you selected.
8. Repeat steps 3 through 7 for the second to fifth coders (optional).
9. Repeat steps 2 through 8 for the second to fourth coder groups (optional).
10. Click the Submit
11. To save the changes to flash memory, refer to ''
SIP User's Manual
Figure 3-68: Coder Group Settings Page
button to save your changes.
118
Saving Configuration'' on page
Document #: LTRT-68809
Mediant 2000
page
173 .