Figure 3-38: Ip Routing Table Page; Table 3-8: Ip Routing Table Description - AudioCodes Mediant 2000 User Manual

SIP User's Manual

To configure static IP routing:
1. Open the 'IP Routing Table' page (Configuration tab > Network Settings menu > IP
Routing Table
2. In the 'Add a new table entry' group, add a new static routing rule according to the
parameters described in the table below.
3. Click Add New Entry
To delete a routing rule from the table, select the 'Delete Row' check box that corresponds
to the routing rule entry, and then click Delete Selected Entries.
Parameter
Destination IP Address
[RoutingTableDestinationsColumn]
Destination Mask
[RoutingTableDestinationMasksColumn]
The address of the host / network you want to reach is determined by an AND operation that is
applied to the fields 'Destination IP Address' and 'Destination Mask'. For example, to reach the
network 10.8.x.x, enter 10.8.0.0 in the field 'Destination IP Address' and 255.255.0.0 in the field
'Destination Mask'. As a result of the AND operation, the value of the last two octets in the field
'Destination IP Address' is ignored.
To reach a specific host, enter its IP address in the field 'Destination IP Address' and 255.255.255.255
in the field 'Destination Mask'.
Gateway IP Address
[RoutingTableGatewaysColumn]
Version 5.8
page item).

Figure 3-38: IP Routing Table Page

; the new routing rule is added to the IP routing table.

Table 3-8: IP Routing Table Description

Specifies the IP address of the destination host /
network.
Specifies the subnet mask of the destination host /
network.
The IP address of the router (next hop) to which the
packets are sent if their destination matches the rules
in the adjacent columns.
Note: The Gateway address must be in the same
subnet on which the address is configured on the
'Multiple Interface Table' page (refer to ''Configuring the
Multiple Interface Table''
65
3. Web-Based Management
Description
on page 56 ).
October 2009