Configuring The Qos Settings; Figure 3-39: Qos Settings Page - AudioCodes Mediant 2000 User Manual

Parameter
Metric
[RoutingTableHopsCountColumn]
Interface
[RoutingTableInterfacesColumn]
3.3.1.5

Configuring the QoS Settings

The 'QoS Settings' page is used for configuring the Quality of Service (QoS) parameters.
This page allows you to assign VLAN priorities (IEEE 802.1p) and Differentiated Services
(DiffServ) for the supported Class of Service (CoS). For a detailed description of the
parameters appearing on this page, refer to ''Networking Parameters'' on page 223. For
detailed information on IP QoS using DiffServ, refer to ''IP QoS via Differentiated Services
(DiffServ)'' on page 452.

To configure QoS:
1. Open the 'QoS Settings' page (Configuration tab > Network Settings menu > QoS
Settings
2. Configure the QoS parameters as required.
3. Click the Submit
4. To save the changes to flash memory, refer to ''
SIP User's Manual
The maximum number of times a packet can be
forwarded (hops) between the device and destination
(typically, up to 20).
Note:
than 0 for the routing rule to be valid. Routing entries
with Hop Count equals 0 are local routes set
automatically by the device.
Specifies the interface (network type) to which the
routing rule is applied.



For detailed information on the network types, refer to
'' Configuring the Multiple Interface Table''
page item).

Figure 3-39: QoS Settings Page

button to save your changes.
Description
This parameter must be set to a number greater
[0] = OAMP (default).
[1] = Media.
[2] = Control.
Saving Configuration''
66
Mediant 2000
on page 56
on page 173 .
Document #: LTRT-68809
.