AudioCodes Mediant 2000 User Manual page 340

Parameter
Web: Generate Inter Digit Time
[CasStateMachineGenerateInterDi
gitTime]
Web: DTMF Max Detection Time
[CasStateMachineDTMFMaxOnDe
tectionTime]
Web: DTMF Min Detection Time
[CasStateMachineDTMFMinOnDet
ectionTime]
Web: MAX Incoming Address Digits
[CasStateMachineMaxNumOfInco
mingAddressDigits]
Web: MAX Incoming ANI Digits
[CasStateMachineMaxNumOfInco
mingANIDigits]
Web: Collect ANI
[CasStateMachineCollectANI]
Web: Digit Signaling System
[CasStateMachineDigitSignalingS
ystem]
[CASSendHookFlash]
SIP User's Manual
Generates digit off-time (in msec).
The value must be a positive value. The default value is -1.
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default value is -1.
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be
longer than this value to receive a detection. Any number may
be used, but the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default value is -1.
Defines the limitation for the maximum address digits that
need to be collected. After reaching this number of digits, the
collection of address digits is stopped.
The value must be an integer. The default value is -1.
Defines the limitation for the maximum ANI digits that need to
be collected. After reaching this number of digits, the
collection of ANI digits is stopped.
The value must be an integer. The default value is -1.
In some cases, when the state machine handles the ANI
collection (not related to MFCR2), you can control the state
machine to collect ANI or discard ANI.

[0] No = Don't collect ANI.

[1] Yes = Collect ANI.

[-1] Default = Default value.
Defines which Signaling System to use in both directions
(detection\generation).

[0] DTMF = Uses DTMF signaling.

[1] MF = Uses MF signaling (default).

[-1] Default = Default value.
Enables sending Wink signal toward CAS trunks.

[0] = Disable (default).

[1] = Enable.
If the device receives a mid-call SIP INFO message with
flashhook event body (as shown below) and this parameter is
set to 1, the device generates a wink signal toward the CAS
trunk. The CAS wink signal is done by changing the A bit from
1 to 0, and then back to 1 for 450 msec.
INFO sip:4505656002@192.168.13.40:5060
SIP/2.0
Via: SIP/2.0/UDP 192.168.13.2:5060
From: <sip:06@192.168.13.2:5060>
To:
<sip:4505656002@192.168.13.40:5060>;tag=1328
78796-1040067870294
Call-ID: 0010-0016-D69A7DA8-1@192.168.13.2
CSeq:2 INFO
Content-Type: application/broadsoft
340
Description
Document #: LTRT-68809
Mediant 2000