3.5.2.4
Viewing IP Connectivity
The 'IP Connectivity' page displays online, read-only network diagnostic connectivity
information on all destination IP addresses configured in the 'Tel to IP Routing' page (refer
to ''Configuring the Tel to IP Routing Table'' on page 138).
Notes:
To view the IP connectivity information:
1.
In the 'Routing General Parameters' page, set the parameter 'Enable Alt Routing Tel to
IP' (or ini file parameter AltRoutingTel2IPEnable) to Enable [1] or Status Only [2]
2.
Open the 'IP Connectivity' page (
menu > IP Connectivity
Column Name
IP Address
The IP address can be one of the following:
Host Name
Host name (or IP address) as defined in the 'Tel to IP Routing' table
'Outbound IP Routing Table' page).
Connectivity
The method according to which the destination IP address is queried
Method
periodically (ICMP ping or SIP OPTIONS request).
SIP User's Manual
•
This information is available only if the parameter 'Enable Alt Routing Tel
to IP'/AltRoutingTel2IPMode (refer to ''Configuring Routing General
Parameters''
on page
•
The information in columns 'Quality Status' and 'Quality Info' (per IP
address) is reset if two minutes elapse without a call to that destination.
page item).
Figure 3-120: IP Connectivity Page
Table 3-42: IP Connectivity Parameters
IP address defined as the destination IP address in the 'Tel to IP Routing'
table (or 'Outbound IP Routing Table' page)
IP address resolved from the host name defined as the destination IP
address in the 'Tel to IP Routing' table
page).
137
) is set to 1 (Enable) or 2 (Status Only).
Status & Diagnostics tab > Gateway Statistics
Description
.
(or 'Outbound IP Routing Table'
194
Mediant 2000
.
(or
Document #: LTRT-68809