AudioCodes Mediant 2000 User Manual page 376

Parameter
EMS: NSE Payload Type
[NSEPayloadType]
Web: V.21 Modem Transport Type
EMS: V21 Transport
[V21ModemTransportType]
Web: V.22 Modem Transport Type
EMS: V22 Transport
[V22ModemTransportType]
Web: V.23 Modem Transport Type
EMS: V23 Transport
[V23ModemTransportType]
Web: V.32 Modem Transport Type
EMS: V32 Transport
[V32ModemTransportType]
Web: V.34 Modem Transport Type
EMS: V34 Transport
[V34ModemTransportType]
EMS: Bell Transport Type
[BellModemTransportType]
SIP User's Manual
100.
In NSE bypass mode, the device starts using G.711 A-Law
(default) or G.711µ-Law according to the parameter
FaxModemBypassCoderType. The payload type used with
these G.711 coders is a standard one (8 for G.711 A-Law and
0 for G.711 µ
-Law). The parameters defining payload type for
the 'old' AudioCodes' Bypass mode FaxBypassPayloadType
and ModemBypassPayloadType are not used with NSE
Bypass. The bypass packet interval is selected according to
the parameter FaxModemBypassBasicRtpPacketInterval.
NSE payload type for Cisco Bypass compatible mode.
The valid range is 96-127. The default value is 105.
Note: Cisco gateways usually use NSE payload type of 100.
V.21 Modem Transport Type used by the device.

[0] Disable = Disable (Transparent) -- default

[1] Enable Relay = N/A

[2] Enable Bypass.

[3] Events Only = Transparent with Events.
V.22 Modem Transport Type used by the device.

[0] Disable = Disable (Transparent)

[1] Enable Relay = N/A

[2] Enable Bypass = (default)

[3] Events Only = Transparent with Events
V.23 Modem Transport Type used by the device.

[0] Disable = Disable (Transparent)

[1] Enable Relay = N/A

[2] Enable Bypass = (default)

[3] Events Only = Transparent with Events
V.32 Modem Transport Type used by the device.

[0] Disable = Disable (Transparent)

[1] Enable Relay = N/A

[2] Enable Bypass = (default)

[3] Events Only = Transparent with Events
Note: This parameter applies only to V.32 and V.32bis
modems.
V.90 / V.34 Modem Transport Type used by the device.

[0] Disable = Disable (Transparent)

[1] Enable Relay = N/A

[2] Enable Bypass = (default)

[3] Events Only = Transparent with Events
Determines the Bell modem transport method.

[0] = Transparent (default).

[2] = Bypass.

[3] = Transparent with events.
376
Description
Document #: LTRT-68809
Mediant 2000