Figure 3-48: Trunk Scroll Bar - AudioCodes Mediant 2000 User Manual

SIP User's Manual
2. Select the trunk that you want to configure, by clicking the desired Trunk number icon.
The bar initially displays the first eight trunk number icons (i.e., trunks 1 through 8). To
scroll through the trunk number icons (i.e., view the next/last or previous/first group of
eight trunks), refer to the figure below:
Note:
After you have selected a trunk, the following is displayed:
•
The read-only 'Trunk ID' field displays the selected trunk number.
•
The read-only 'Trunk Configuration State' displays the state of the trunk (e.g.,
'Active' or 'Inactive').
•
The parameters displayed in the page pertain to the selected trunk only.
1. Click the Stop Trunk
out of service so that you can configure the currently grayed out (unavailable)
parameters.(Skip this step if you want to configure parameters that are available when
the trunk is active). The stopped trunk is indicated by the following:
•
The 'Trunk Configuration State' field displays 'Inactive'.
•
The Stop Trunk button is replaced by the Apply Trunk Settings
(When all trunks are stopped, the Apply to All Trunks
•
All the parameters are available and can be modified.
2. Configure the desired trunk parameters.
3. Click the Apply Trunk Settings button to apply the changes to the selected trunk (or
click Apply to All Trunks to apply the changes to all trunks); the Stop Trunk button
replaces Apply Trunk Settings
4. To save the changes to flash memory, refer to ''
5. To reset the device, refer to ''Resetting the Device''
Version 5.8

Figure 3-48: Trunk Scroll Bar

If the Trunk scroll bar displays all the available trunks, the scroll bar buttons
are unavailable.
button (located at the bottom of the page) to take the trunk
and the 'Trunk Configuration State' displays 'Active'.
Saving Configuration''
on page
75
3. Web-Based Management
button.
button also appears.)
on page 173
171 .
October 2009
.