Radius Parameters; Table 6-27: Radius Parameters - AudioCodes Mediant 2000 User Manual

Parameter
EMS: OCSP Default
Response
[OCSPDefaultResponse]
6.5

RADIUS Parameters

The RADIUS parameters are described in the table below. For detailed information on the
supported RADIUS attributes, refer to ''Supported RADIUS Attributes'' on page 426.
Parameter
Web: Enable RADIUS Access
Control
[EnableRADIUS]
Web: Accounting Server IP
Address
[RADIUSAccServerIP]
Web: Accounting Port
[RADIUSAccPort]
Web/EMS: RADIUS Accounting
Type
[RADIUSAccountingType]
Web: AAA Indications
EMS: Indications
[AAAIndications]
Web: Device Behavior Upon
RADIUS Timeout
[BehaviorUponRadiusTimeout]
[MaxRADIUSSessions]
[RADIUSRetransmission]
[RadiusTO]
SIP User's Manual
Determines the default OCSP behavior when the server cannot be
contacted.

[0] = Rejects peer certificate (default).

[1] = Allows peer certificate.

Table 6-27: RADIUS Parameters

Determines whether the RADIUS application is enabled.

[0] Disable = RADIUS application is disabled (default).

[1] Enable = RADIUS application is enabled.
Note: For this parameter to take effect, a device reset is required.
IP address of the RADIUS accounting server.
Port of the RADIUS accounting server.
The default value is 1646.
Determines when the RADIUS accounting messages are sent to
the RADIUS accounting server.

[0] At Call Release = Sent at call release only (default).

[1] At Connect & Release = Sent at call connect and release.

[2] At Setup & Release = Sent at call setup and release.
Determines the Authentication, Authorization and Accounting
(AAA) indications.

[0] None = No indications (default).

[3] Accounting Only = Only accounting indications are used.
Defines the device's response upon a RADIUS timeout.

[0] Deny Access = Denies access.

[1] Verify Access Locally = Checks password locally (default).
Number of concurrent calls that can communicate with the
RADIUS server (optional).
The valid range is 0 to 240. The default value is 240.
Number of retransmission retries.
The valid range is 1 to 10. The default value is 3.
Determines the time interval (measured in seconds) the device
waits for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default value is 10.
256
Description
Description
Document #: LTRT-68809
Mediant 2000