AudioCodes Mediant 2000 User Manual page 311

SIP User's Manual
Parameter
EMS: Time Out
[AMDTimeout]
EMS: Detection Direction
[AMDDetectionDirection]
Energy Detector Parameters
Enable Energy Detector
[EnableEnergyDetector]
Energy Detector Quality Factor
[EnergyDetectorQualityFactor]
Energy Detector Threshold
[EnergyDetectorThreshold]
Pattern Detection Parameters
Note: For an overview on the pattern detector feature for TDM tunneling, refer to DSP Pattern
Detector on page 484.
Web: Enable Pattern Detector
[EnablePatternDetector]
[PDPattern]
[PDThreshold]
Version 5.8
Timeout (in msec) between receiving CONNECT messages from
the ISDN and sending AMD results.
The valid range is 1 to 30,000. The default is 2,000 (i.e., 2
seconds).
Determines the AMD detection direction.

[0] = Detection from the PSTN side (default)

[1] = Detection from the IP side
Currently, not supported.
Currently, not supported.
Currently, not supported.
Enables or disables the activation of the Pattern Detector (PD).
Valid options include:

[0] Disable = Disable (default)

[1] Enable = Enable
Defines the patterns that can be detected by the Pattern Detector.
The valid range is 0 to 0xFF.
Note: For this parameter to take effect, a device reset is required.
Defines the number of consecutive patterns to trigger the pattern
detection event.
The valid range is 0 to 31. The default is 5.
Note: For this parameter to take effect, a device reset is required.
311
6. Configuration Parameters Reference
Description
October 2009