Figure 3-87: Trunk Group Settings - AudioCodes Mediant 2000 User Manual

SIP User's Manual
Parameter
Tel Profile ID
[TrunkGroup_ProfileId]
3.3.7.10.2 Configuring Trunk Group Settings
The 'Trunk Group Settings' page allows you to configure up to 24 Trunk Groups. These
Trunk Groups can be assigned ID's between 1 and 99. The device's channels can be
conveniently assigned to these Trunk Groups in the 'Trunk Group Table' page (refer to
"Configuring the Trunk Group Table" on page 155).
The 'Trunk Group Settings' page is also used to select the method for which IP-to-Tel calls
are assigned to channels within each Trunk Group. If no method is selected (for a specific
Trunk Group), the setting of the global parameter ChannelSelectMode applies. In addition,
this page defines the method for registering Trunk Groups to selected Serving IP Group IDs
(if defined).
Note:

To configure the Trunk
1. Open the '
menu > Trunk Group submenu > Trunk Group Settings
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
edit (up to 24 entries can be configured).
3. Configure the Trunk
4. Click the
5. To save the changes to flash memory, refer to ''
Version 5.8

You can define the method for which new calls are
assigned to channels within the Trunk
parameter TrunkGroupSettings.
The Tel Profile ID assigned to the channels pertaining to the
Trunk Group.
Note: For configuring Tel Profiles, refer to the parameter
TelProfile.
You can also configure the Trunk Group Settings table using the ini file table
parameter TrunkGroupSettings (refer to ''Number Manipulation and Routing
Parameters'' on page 348
Group Settings table:
Trunk Group Settings' page (Configuration tab > Protocol Configuration
Figure 3-87: Trunk Group Settings Page
Group according to the table below.
Submit button to save your changes.
Description
).
Saving Configuration''
157
3. Web-Based Management
Groups, using the
page item).
on page 173
October 2009
.