Provisioning Sip Parameters; Figure 3-4: Mediant 2000/Sip Quick Setup - AudioCodes Mediant 2000 Installation Manual

3.4

Provisioning SIP Parameters

After completing steps
accessed, as shown in
To provision basic SIP parameters, take these 11 steps:
1. If the Mediant 2000 is behind a router with NAT enabled, take the following procedures:
Determine the "public" IP address assigned to the router (by using, for instance, router
Web management). This "public IP address" is used to configure the Mediant 2000
Static NAT IP address.
Enable the DMZ configuration on the residential router for the LAN port where the
Mediant 2000 gateway is connected.
Enter the public IP address for the Mediant 2000 in the 'NAT IP Address' field (in
addition to the gateway's local IP address).
2. In the 'Default Gateway IP Address' field, enter the IP address for the default gateway. If you
do not know the IP address for the default gateway, contact your network administrator.
Enter 0.0.0.0 if default gateway isn't used.
3. Under 'SIP Parameters', enter the Mediant 2000 domain name in the field 'Gateway Name'.
If the field is not specified, the Mediant 2000 IP address will be used instead (default).
4. When working with a Proxy server, set 'Working with Proxy' field to 'Yes' and enter the IP
address of the primary Proxy server in the field 'Proxy IP address'. When no Proxy is used,
the internal routing table is used to route the calls.
5. Enter the Proxy name in the field 'Proxy Name'. If Proxy name is used, it will replace the
Proxy IP address in all SIP messages. This means that messages will still be sent to the
physical Proxy IP address but the SIP URI will contain the Proxy name instead.
Mediant 2000
1 to 10 (pages 14 & 15) under Section 3.1, the SIP 'Quick Setup' screen is
Figure 3-4.

Figure 3-4: Mediant 2000/SIP Quick Setup

20
Mediant 2000
Document #: LTRT-70102