Configuring Trunks; General Trunk Configuration; Figure 5-5: Trunk Sip Provisioning Frame - AudioCodes Mediant 2000 User Manual

Note:
5.4

Configuring Trunks

This section describes how to provision the E1/T1 PSTN Trunks.


''General Trunk Configuration''


Trunk configuration also includes ISDN NFAS, as described in ''Configuring ISDN
NFAS''
5.4.1 General Trunk Configuration
This section describes how to provision a PSTN trunk.

To provision a trunk:
1. In the MG Tree, select the required device; the device's graphical display is shown in
the Status pane.
2. Double-click the Trunk module
3. In the DS1 Carriers List table, double-click a Trunk; the Trunk SIP Provisioning screen
is displayed with the
4. From the 'Protocol Type' drop-down list, select the required protocol.
5. From the 'Framing Method' drop-down list, select the required framing method. For E1,
always set this parameter to Extended Super Frame.
SIP User's Manual
The Pre-shared Key string defined in the EMS must be identical to the one
that you defined for the device. When IPSec is enabled, default IPSec/IKE
parameters are loaded to the device.
on page 209
; the DS1 Carriers List table appears.
General Settings

Figure 5-5: Trunk SIP Provisioning Frame

on page 208
tab selected.
208
Mediant 2000
Document #: LTRT-68809