AudioCodes Mediant 2000 User Manual page 235

SIP User's Manual
Parameter
EMS: DHCP Speed Factor
[DHCPSpeedFactor]
[EnableDHCPLeaseRenewal]
Version 5.8
(soft reset via Web interface doesn't trigger the BootP/DHCP
procedure and this parameter reverts to 'Disable').

Throughout the DHCP procedure the BootP/TFTP application
must be deactivated, otherwise, the device receives a response
from the BootP server instead of from the DHCP server.

For additional information on DHCP, refer to the Product
Reference Manual .

This parameter is a special 'Hidden' parameter. Once defined
and saved in flash memory, its assigned value doesn't revert to
its default even if the parameter doesn't appear in the
Determines the DHCP renewal speed.

[0] = Disable

[1] = Normal (default)

[2] to [10] = Fast
When set to 0, the DHCP lease renewal is disabled. Otherwise, the
renewal time is divided by this factor. Some DHCP-enabled routers
perform better when set to 4.
Note: For this parameter to take effect, a device reset is required.
Enables or disables DHCP renewal support.

[0] = Disable (default)

[1] = Enable
This parameter is applicable only if DHCPEnable is set to 0 for
cases where booting up the device using DHCP is not desirable, but
renewing DHCP leasing is. When the device is powered up, it
attempts to communicate with a BootP server. If there is no
response and if DHCP is disabled, the device boots from flash. It
then attempts to communicate with the DHCP server to renew the
lease.
Note: For this parameter to take effect, a device reset is required.
235
6. Configuration Parameters Reference
Description
ini file.
October 2009