Figure 3-84: Release Cause Mapping - AudioCodes Mediant 2000 User Manual

3.3.7.9.8 Configuring Release Cause Mapping
The 'Release Cause Mapping' page consists of two groups that allow the device to map up
to 12 different SIP Response Codes to Q.850 Release Causes and vice versa, thereby
overriding the hard-coded mapping mechanism (described in ''Release Reason Mapping''
on page 472).
Note:

To configure Release Cause Mapping:
1. Open the 'Release Cause Mapping' page (Configuration tab > Protocol
Configuration menu > Routing Tables submenu > Release Cause Mapping
item).
2. In the 'Release Cause Mapping from ISDN to SIP' group, map (up to 12) different
Q.850 Release Causes to SIP Responses.
3. In the 'Release Cause Mapping from SIP to ISDN' group, map (up to 12) different SIP
Responses to Q.850 Release Causes.
4. Click the Submit
5. To save the changes so they are available after a power fail, refer to ''
Configuration''
SIP User's Manual
You can also configure SIP Responses-Q.850 Release Causes mapping
using the ini file
CauseMapSIP2ISDN (refer to ''ISDN and CAS Interworking-Related
Parameters'' on page 325
Figure 3-84: Release Cause Mapping Page
button to save your changes.
on page 173 .
table parameters
).
152
Mediant 2000
CauseMapISDN2SIP
Saving
Document #: LTRT-68809
and
page