Figure 3-79: Outbound Ip Routing; Table 3-28: Outbound Ip Routing Table Description - AudioCodes Mediant 2000 User Manual

SIP User's Manual
This table allows you to configure the device's routing rules for sending inbound IP calls
matching some or all of the following criteria to a destination IP address or IP Group:

Source IP Group

Source host prefix

Destination host prefix

Trunk Group

Destination telephone prefix

Source telephone prefix

To configure Outbound IP Routing:
1. Open the 'Outbound IP Routing Table' page (Configuration tab > Protocol
Configuration menu > Routing Tables submenu > Tel to IP Routing
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3. Configure the Outbound IP Routing table according to the table below.
4. Click the Submit
5. To save the changes to flash memory, refer to ''
Parameter
Tel to IP Routing Mode
[RouteModeTel2IP]
Src. IPGroupID
[PREFIX_SrcIPGroupID]
Version 5.8
Figure 3-79: Outbound IP Routing Page
button to save your changes.

Table 3-28: Outbound IP Routing Table Description

Determines whether to route the inbound IP calls to the IP
destination before or after manipulation of destination number.

[0] Route calls before manipulation = IP-to-IP calls are routed
before the number manipulation rules are applied (default).

[1] Route calls after manipulation = IP-to-IP calls are routed after
the number manipulation rules are applied.
Note: Not applicable if outbound Proxy routing is used.
The IP Group ID from where the IP-to-IP call originated. Typically,
the IP Group of an incoming INVITE is determined according to the
'Inbound IP Routing' table. To denote all IP Groups, leave the field
empty.
Notes:

If this Source IP Group has a Serving IP Group, then all calls
Saving Configuration''
Description
143
3. Web-Based Management
page item).
on page 173
October 2009
.