Figure 3-108: Message Log Screen - AudioCodes Mediant 2000 User Manual


To activate the Message Log:
1. Set the parameter 'Debug Level' (GwDebugLevel) to 6 (refer ''Configuring Advanced
Parameter''
range 0 to 6, where 6 is the highest level.
2. Open the 'Message Log' page (Status & Diagnostics tab > Status & Diagnostics
menu > Message Log
activated.
The displayed logged messages are color coded as follows:
•
Yellow - fatal error message
•
Blue - recoverable error message (i.e., non-fatal error)
•
Black - notice message
3. To clear the page of Syslog messages, access the 'Message Log' page again (see
Step 2); the page is cleared and new messages begin appearing.

To stop the Message Log:

Close the 'Message Log' page by accessing any another page in the Web interface.
SIP User's Manual
on page 122 ). This parameter determines the Syslog logging level in the
page item); the 'Message Log' page is displayed and the log is

Figure 3-108: Message Log Screen

184
Mediant 2000
Document #: LTRT-68809