AudioCodes Mediant 2000 User Manual page 356

Parameter
Web: Alt Routing Tel to IP
Connectivity Method
EMS: Alternative Routing
Telephone to IP Connection
Method
[AltRoutingTel2IPConnMethod]
[EnableAltMapTel2IP]
Web: Alt Routing Tel to IP Keep
Alive Time
EMS: Alternative Routing Keep
Alive Time
[AltRoutingTel2IPKeepAliveTime]
Web: Max Allowed Packet Loss for
Alt Routing [%]
[IPConnQoSMaxAllowedPL]
Web: Max Allowed Delay for Alt
Routing [msec]
[IPConnQoSMaxAllowedDelay]
Web: Reasons for Alternative Tel-to-IP Routing Table
EMS: Alt Route Cause Tel to IP
[AltRouteCauseTel2IP]
SIP User's Manual
2 or 3.
Determines the method used by the device for periodically
querying the connectivity status of a destination IP address.

[0] ICMP Ping (default) = Internet Control Message Protocol
(ICMP) ping messages.

[1] SIP OPTIONS = The remote destination is considered
offline if the latest OPTIONS transaction timed out. Any
response to an OPTIONS request, even if indicating an
error, brings the connectivity status to online.
Enables different Tel-to-IP destination number manipulation
rules per routing rule when several (up to three) Tel-to-IP
routing rules are defined and if alternative routing using release
causes is used. For example, if an INVITE message for a Tel-
to-IP call is returned with a SIP 404 Not Found response, the
call can be re-sent to a different destination number (as
defined using the parameter NumberMapTel2IP).

[0] = Disable (default)

[1] = Enable
Defines the time interval (in seconds) between SIP OPTIONS
Keep-Alive messages used for the IP Connectivity application.
The valid range is 5 to 2,000,000. The default value is 60.
Packet loss percentage at which the IP connection is
considered a failure and Alternative Routing mechanism is
activated.
The range is 1 to 20%. The default value is 20%.
Transmission delay (in msec) at which the IP connection is
considered a failure and Alternative Routing mechanism is
activated.
The range is 100 to 1000. The default value is 250.
This ini file table parameter configures SIP call failure reason
values received from the IP side. If an IP call is released as a
result of one of these reasons, the device attempts to locate an
alternative IP route (address) to the call in the 'Tel to IP
Routing' table (if a Proxy is not used) or used as a redundant
Proxy (you need to set the parameter RedundantRoutingMode
to 2). The release reason for Tel-to-IP calls is provided in SIP
4xx, 5xx, and 6xx response codes.
The format of this parameter is as follows:
[AltRouteCauseTel2IP]
FORMAT AltRouteCauseTel2IP_
AltRouteCauseTel2IP_ReleaseCause
[\AltRouteCauseTel2IP]
For example:
AltRouteCauseTel2IP 0 = 486; (Busy Here)
AltRouteCauseTel2IP 1 = 480; (Temporarily Unavailable)
AltRouteCauseTel2IP 2 = 408; (No Response)
356
Description
Index =
;
Document #: LTRT-68809
Mediant 2000