Table 3-32: Trunk Group Settings Parameters - AudioCodes Mediant 2000 User Manual

An example is shown below of a REGISTER message for registering endpoint "101" using
registration Per Endpoint mode. The "SipGroupName" in the request URI is taken from the
IP Group table.
REGISTER sip:SipGroupName SIP/2.0
Via: SIP/2.0/UDP 10.33.37.78;branch=z9hG4bKac862428454
From: <sip:101@GatewayName>;tag=1c862422082
To: <sip:101@GatewayName>
Call-ID: 9907977062512000232825@10.33.37.78
CSeq: 3 REGISTER
Contact: <sip:101@10.33.37.78>;expires=3600
Expires: 3600
User-Agent: Audiocodes-Sip-Gateway/v.5.80A.008.002
Content-Length: 0
Parameter
Trunk Group ID
[TrunkGroupSettings_TrunkGr
oupId]
Channel Select Mode
[TrunkGroupSettings_Channel
SelectMode]
Registration Mode
[TrunkGroupSettings_Registra
tionMode]
SIP User's Manual

Table 3-32: Trunk Group Settings Parameters

The Trunk Group ID that you want to configure.
The valid range is 1 to 99.
The method for which IP-to-Tel calls are assigned to channels
pertaining to a
parameter, refer to the global parameter ChannelSelectMode.

[0] By Dest Phone Number.

[1] Cyclic Ascending (default)

[2] Ascending

[3] Cyclic Descending

[4] Descending

[5] Dest Number + Cyclic Ascending

[6] By Source Phone Number

[7] Trunk Cyclic Ascending
Registration method for the

[1] Per Gateway = Single registration for the entire device
(default). This mode is applicable only if a default Proxy or
Registrar IP are configured, and Registration is enabled (i.e.,
parameter IsRegisterUsed is set to 1). In this mode, the SIP
URI user part in the From, To, and Contact headers is set to
the value of the global registration parameter
GWRegistrationName (refer to ''Configuring Proxy and
Registration Parameters''
GWRegistrationName is not configured.

[0] Per Endpoint = Each channel in the Trunk
individually. The registrations are sent to the
ServingIPGroupID if defined in the table, otherwise to the
default Proxy, and if no default Proxy, then to the Registrar IP.

[4] Don't Register = No registrations are sent by endpoints
pertaining to the Trunk Group. For example, if the device is
configured globally to register all its endpoints (using the
parameter ChannelSelectMode), you can exclude some
endpoints from being registered by assigning them to a Trunk
Group and configuring the Trunk Group registration mode to
158
Description
Trunk Group. For a detailed description of this
Trunk Group:
on page 101
Mediant 2000
) or username if
Group registers
Document #: LTRT-68809