Sip Advanced Parameters; Table 3-22: Description Of Parameter Unique To Ip Profile - AudioCodes Mediant 2000 User Manual

4. From the 'Profile Preference' drop-down list, select the priority of the IP Profile, where
'1' is the lowest priority and '20' is the highest. If both IP and Tel profiles apply to the
same call, the coders and other common parameters (noted by an asterisk) of the
preferred Profile are applied to that call. If the Preference of the Tel and IP Profiles is
identical, the Tel Profile parameters are applied.
Note: If the coder lists of both IP and Tel Profiles apply to the same call, only the
coders common to both are used. The order of the coders is determined by the
preference.
5. Configure the IP Profile's parameters according to your requirements. Parameters that
are unique to IP Profile are described in the table below.
6. From the 'Coder Group' drop-down list, select the coder group that you want to assign
to the IP Profile. You can select the device's default coders (refer to ''Configuring
Coders''
Settings' page (refer to ''Configuring Coder Groups''
7. Repeat steps 2 through 6 for the next IP Profiles (optional).
8. Click the Submit
9. To save the changes to flash memory, refer to ''

Table 3-22: Description of Parameter Unique to IP Profile

Parameter
Number of Calls Limit
3.3.7.6

SIP Advanced Parameters

The SIP Advanced Parameters submenu allows you to configure advanced SIP control
protocol parameters. This submenu contains the following page items:

Advanced Parameters (refer to ''Configuring Advanced Parameters''

Supplementary Services (refer to ''Configuring Supplementary Services''
3.3.7.6.1 Configuring Advanced Parameters
The 'Advanced Parameters' page allows you to configure advanced SIP control
parameters. For a description of the parameters appearing on this page, refer to
''Configuration Parameters Reference'' on page 223.
SIP User's Manual
on page 115 ), or one of the coder groups you defined in the 'Coder Group
button to save your changes.
Maximum number of concurrent calls. If the profile is set to some limit, the
device maintains the number of concurrent calls (incoming and outgoing)
pertaining to the specific profile. A limit value of '-1' indicates that there is
no limitation on calls for that specific profile (default). A limit value of '0'
indicates that all calls are rejected. When the number of concurrent calls is
equal to the limit, the device rejects any new incoming and outgoing calls
belonging to that profile.
on page
Saving Configuration''
Description
122
Mediant 2000
117 ).
on page 173 .
on page 122 )
on page 123
Document #: LTRT-68809
)