AudioCodes Mediant 2000 User Manual page 339

SIP User's Manual
Parameter
[EnableTransferAcrossTrunkGrou
ps]
CAS Parameters
Note: For configuring the 'CAS State Machine' table using the Web interface, refer to ''Configuring the
CAS State Machines''
Web: CAS Transport Type
EMS: CAS Relay Transport Mode
[CASTransportType]
[CASAddressingDelimiters]
[CASDelimitersPaddingUsage]
Web: Generate Digit On Time
[CasStateMachineGenerateDigitO
nTime]
Version 5.8
After completing the in-band transfer, the device waits for
the ISDN Disconnect message. If the Disconnect message
is received during the first 5 seconds, the device sends a
SIP NOTIFY with 200 OK message; otherwise, the device
sends a NOTIFY with 4xx message.
Determines whether the device allows ISDN ECT, RLT or
TBCT IP-to-Tel call transfers between B-channels from
different trunks or Trunk Groups.

[0]
channels of the same trunk or Trunk Group (default).

[1]
any two PSTN calls (between any trunk or Trunk Group)
handled by the device.
Note: The ISDN transfer also requires that you configure the
parameter TrunkTransferMode_x to 2.
on page 76 .
Controls the ABCD signaling transport type over IP.

[0]

[1] CAS RFC2833 Relay = Enable CAS relay mode using
RFC 2833.
The CAS relay mode can be used with the TDM tunneling
feature to enable tunneling over IP for both voice and CAS
signaling bearers.
Determines if delimiters are added to the received address or
received ANI digits string.

[0]

[1]
When this parameter is enabled, delimiters such as '*', '#', and
'ST' are added to the received address or received ANI digits
string. When it is disabled, the address and ANI strings remain
without delimiters.
Defines the digits string delimiter padding usage per trunk.

[0]
(where XXX is the digit string that begins with '*' and ends
with '#', when using padding).

[1] = special use of asterisks delimiters: '*XXX*YYY*'
(where XXX is the address, YYY is the source phone
number, and '*' is the only delimiter padding).
Note:
required.
Generates digit on-time (in msec).
The value must be a positive value. The default value is -1.
6. Configuration Parameters Reference
Description
= Disable - ISDN call transfer is only between B-
= Enable - the device performs ISDN transfer between
CAS Events Only = Disable CAS relay (default).
= Disable (default)
= Enable
(default) = default address string padding: '*XXX#'
For this parameter to take effect, a device reset is
339 October 2009